Home > Hard Drive > XP Cannot Read My Hard Drive

XP Cannot Read My Hard Drive


Reply Guy Gilbert October 19, 2016 at 2:05 pm My external hard drive is nearly full and is readily recognisable on my Windows 8.1 system but not on Windows 10. try the things they say to start with but if they fail, rip it out of enclosure, plug into spare sata port on pc. If you want to run in AHCI mode, then you MUST do this......2. I'm positive it's SP3. useful reference

Please help me recover the hard drive, if possible, without loosing data. Reply LynnL June 28, 2016 at 7:50 pm I bought a laptop 2.5 drive and put it in to an external case. Cables to the disk (in my case, going to an external USB 2.0 hub) were checked and found to be OK. Run recovery program and you might be lucky like me to recover 2 years of kids photos.

External Hard Drive Not Showing Up In My Computer

Reply Craig September 30, 2016 at 3:36 am Every other forum and bit of info google found never worked! Reply Keith November 12, 2016 at 6:48 pm None of these steps work. Any input would be appreciated!!

there is no yellow exclamation mark next to it though so i wasnt sure what to do next. in disk management it says that it is Removable, 7.87Gb read Only, and it shows the primary partition is 7.87 GB RAW, Healthy (Active, Primary Partition). I checked in diskmgmt. Usb Drive Not Showing Up Windows 7 Only one I can click on is Properties or Help, properties said it is working properly, and help is very unhelpful.

please help. External Hard Drive Not Recognized Windows 10 To fix this problem, simply reformat the NTFS partition as FAT32. Trying to recover files from an old console HDD after putting it in to an enclosure case. but i can see that device at task bar for ejection.

If you trying to setup a USB drive. External Hard Drive Not Working click ok and your drive should be visible. In the CCabs\D00455-001-001 folder, double-click F6flpy32.exe.4. I've looked on eBay, but none of the are actual Gateway restore discs - they're driver updates only that require XP to already be loaded.

External Hard Drive Not Recognized Windows 10

prior to jacking it into my XP it wasn't recognized in vista. It did nothing (although it worked with something else before) So any help would be great! External Hard Drive Not Showing Up In My Computer My Windows XP bios shows my new SATA drive, but Disk Management does not. External Hard Drive Not Detected To find out more and change your cookie settings, please view our cookie policy.

solved BIOS doesn't see hard drive, win 7 installer does. see here Leave a comment Helpful +32 Report twinstaiye May 7, 2013 at 07:40 AM here is what I did. By viewing our content, you are accepting the use of cookies. E,F,G,H). External Hard Drive Not Showing Up In Disk Management

Fixed it in literally 5 minutes following you're detailed instructions. Or is it something else that is making the computer not recognize the drive?Please help!Tyson Share Flag This conversation is currently closed to new comments. 7 total posts (Page 1 of Helpful +4 Report JohannK Jun 25, 2009 at 10:34 AM This is happening to me too since I installed IE8 Compatibiliity view list update and the .NET 3.5 SP1. http://upxpress.net/hard-drive/windows-vista-sata-hard-drive-slave-drive.php Verify there are no errors in the USB section.

Honeywell Lyric: Which Smart Thermostat Should You Buy? Internal Hard Disk Not Detected Some sort of a constant solution for this problem would be nice. This WD Elements USB hard drive was working fine.

Was this answer helpful?

You may want to use the Update Driver button to install an updated driver, use the Roll Back Driver button to revert any changes, or use the Uninstall button to uninstall What are the chances, it is brand new! now, how to partition it into two logical drives ? External Hard Drive Not Recognized Mac That made my hard drive to go to GPT Partition.

so know.In a worse case sitution (IBM stink pads) it can be near impossible ,sans IBM disks.but on a gateway , you , must learn what it needs)what are the chip solved Data Hard-Drive Crashed - Bios see it, Win 7 doesn't Tom's Hardware Around the World Tom's Hardware Around the World Denmark Norway Finland Russia France Turkey Germany UK Italy USA First, let’s check whether Windows detects the drive when you plug it in. http://upxpress.net/hard-drive/wipe-drive-six-ruined-my-hard-drive.php If it works in one USB port but not another, you may have a dead USB port Dead USB Port?

This especially true in external drives TB and up. read the chip write down the number.btw , if you want, with XPlite , a product you can make a new XP disk that has all the sata drivers ON CD Maybe this has something to do with the logic of the controller in a NexSTAR enclosure? MousemonkeyJan 30, 2012, 6:43 AM This topic has been closed by Mousemonkey Ask a new question Read More Chipsets BIOS Hard Drives SATA Motherboards Related Resources solved Windows XP doesn't see

Got the ISO from MSDN. You can set it to IDE mode. It takes less than a minute and is completely free! Awesome, it's fixed.

Solved the problem in the easiest way - Many thanks. If anyone can find what setting has changed please reply so we can all modify this pointless bug. You saved me a lot of money -- Singapore about $300 ! any ideas?

I am soooooooo frustrated!!! I am about to have a heart attack if I've lost all of my data! The disk controller will eventually reset itself if the power is left off for a while(i.e., the disk is unplugged), but this is inconvenient.