Home > Windows Xp > Windows XP Boot Up Floppy Disk Needed

Windows XP Boot Up Floppy Disk Needed

Contents

Privacy Policy | Cookies | Ad Choice | Terms of Use | Mobile User Agreement A ZDNet site | Visit other CBS Interactive sites: Select SiteCBS CaresCBS FilmsCBS RadioCBS.comCBS InteractiveCBSNews.comCBSSports.comChowhoundClickerCNETCollege NetworkGameSpotLast.fmMaxPrepsMetacritic.comMoneywatchmySimonRadio.comSearch.comShopper.comShowtimeTech Typically, the MBR resides on the first sector of the hard disk. To use the Last Known Good Configuration feature, first restart the computer by pressing [Ctrl][Alt][Delete]. Or words to that effect. Source

This feature will allow you to undo any changes that caused problems in the CurrentControlSet registry key, which defines hardware and driver settings. Ntldr must be located in root folder of the active partition along with Ntdetect.com, boot.ini, bootsect.dos (for dual booting) and Ntbootdd.sys (needed with some SCSI adapters) The operating system is ‘selected’ Last Known Good Configuration The Last Known Good Configuration option on the Windows Advanced Options Menu starts your computer using the configuration it stored at the last successful closedown. How to use a boot disk To use the floppy, simply insert the boot disk into your computer's floppy drive and start or reboot your computer.When your computer starts, it will

How To Make A Bootable Floppy Disk

However, Microsoft has downloads available for users who still need to create bootable diskettes to install (not upgrade) Windows XP. Heck, those older versions of Windows stepped you through a complicated procedure for creating a two-disk set that could help you cure whatever ailed Windows. They work only with the old-fashioned FAT32 hard drive format. So what could happen?

The Redirect parameter takes two parameters of its own, [Port Baudrate ] | [UseBiosSettings]. /Disableredirect—Disables the redirection. #6: Fix a corrupt partition boot sector The partition boot sector is a small Just work through the sections in turn until you find something relevant to your problem. 1. Boot (i.e. Create Bootable Floppy Image Users who read this also read: Introduction to the Windows Command Prompt Before Windows was created, the most common operating system that ran on IBM PC compatibles was DOS.

CH000012 Receiving error "Missing command interpreter" CH000280 How to create a Windows ERD. Bootable Floppy Image To display this menu, you need to power off your computer and then restart it. Safe Mode If you choose Safe Mode on the Advanced Options Menu, Windows will attempt to start up in a special mode where only its most basic components are loaded. Some advice is given on doing this in a separate document.

DOS stands for Disk Operating System and was what you would use if you had started your computer much like you do today with Windows. Dos Boot Disk Windows 7 Comments Facebook Linkedin Twitter More Email Print Reddit Delicious Digg Pinterest Stumbleupon Google Plus About Greg Shultz Greg Shultz is a freelance Technical Writer. On the Welcome to System Restore screen, select Restore my computer to an earlier time (if it is not already selected), and then click Next. Windows XP's Format dialog box appears, as shown in Figure 67-1. 3.

Bootable Floppy Image

On the [Select a Restore Point] screen, click the most recent system checkpoint in the On this list, click a restore point list, and then click Next. If they tell you all the recovery files are on the hard drive, ask ‘em what you're supposed to do if your hard drive dies — by far the most likely How To Make A Bootable Floppy Disk mspx. Scan Disk Checks And Fixes For an introduction to some of the commands you type in DOS, you can read our tutorial here: Introduction to the Windows Command Prompt As always, if you have any questions,

The last version of Windows with functioning boot disks was Windows Me. http://upxpress.net/windows-xp/xp-boot-disk-from-oem-windows-installation.php The Boot.ini file will most always be the problem with the boot disk unless the boot disk is corrupted, damaged, infected, etc. At the prompt, if you have MS-DOS 6.2, Windows 3.x, Windows 95, Windows 98, type: FORMAT A:/S If you have MS-DOS 5.0 Type using double density 5.25" diskettes type: FORMAT A: If your computer's problem is so serious that it won't get as far as the Advanced Options Menu, skip to the section below on Windows Repair Installation. 4. Create Ms Dos Startup Disk Windows 7

  • It needs to be blank and virus free.
  • Getting the CD You Deserve Rant /ON.
  • Once you have copied the above files, create an autoexec.bat and a config.sys.
  • Once this is displayed, press enter to copy the file.
  • When it finds the previous installation, you'll see a second Windows XP Setup screen, as shown in Figure C.
  • Ntoskrnl.exe and Hal.dll must be located in the %SystemRoot%\System32 folder.
  • To create a boot disk for Windows XP for an NTFS or FAT Partition you will need to have a formatted floppy.
  • The difference was that DOS was not a graphical operating system but rather purely textual.

No, you can't boot from a floppy disk and then run Windows from the CD. The latter will fix your system by restoring it to exactly how it was when it left the factory - all your own files and any new software that you installed How to install and use the Windows XP Recovery Console The Recovery Console is a special boot up method that can be used to help fix problems that are preventing your http://upxpress.net/windows-xp/windows-xp-will-not-boot-even-from-boot-disk.php Once you are in DOS and at the correct directory as instructed in the above sections by operating system, you are ready to create your bootable diskette.

When the file has completed downloading you will see an icon similar to the one below with a name that corresponds to the operating system you chose for the boot disk. Windows Xp Boot Disk Download There was a little check box in the disk formatting dialog box that claimed it would create a boot disk — but the generated floppy amounted to little more than a Using Windows to create you a Windows 98 boot diskette gives you all the needed files as well as CD-ROM support.

Creating an MS-DOS boot disk Creating a Windows 3.x boot disk Creating a Windows 95 boot disk Creating a Windows 98 or ME boot disk Creating a Windows NT boot disk

It may look something like this: default=multi (0)disk (0)partition (2) \WINDOWS[operating systems]multi(0)disk(0)partition(2)\WINDOWS="Microsoft Windows XP" /fastdetect Ntdetect.com can start to gather information about your systems hardware (such as): Computer ID Bus/adapter type Shimonski Posted On November 30, 2004 0 100 Views 0 0 Shares Share On Facebook Tweet It Use the procedures in this article to work around the problems that hinder your system If you have an NTFS drive (and you probably do if you bought your PC with Windows XP preinstalled), you can boot to DOS till the cows come home, but unless Windows Xp Floppy Boot Disk When the disks are assembled, you stick disk number one in your floppy drive, restart your machine, keep feeding it diskettes, and ultimately you get to the Windows XP setup routine,

Format your Floppy. The steps here create a floppy disk that will boot your PC, bypassing the key files on your hard drive. This blog post is available in PDF format as a TechRepublic Download. Check This Out To use the Fixboot tool, from the Recovery Console command prompt, type Fixboot [drive]: Where [drive] is the letter of the drive to which you want to write a new partition

You have access to all your files on all your drives, all your hardware should be chugging away, and you can scramble around madly backing up your files in anticipation of They won't let you do anything except start your computer and install Windows XP from a CD. You'll then find yourself at the main Recovery Console prompt. When you see the message Please select the operating system to start or hear the single beep, press [F8] to display the Windows Advanced Options menu.

Use of this option is beyond the scope of this document. 6. Open My Computer, right-click the A: drive and click Format. I wouldn't bet the farm on it, but it may solve some sticky problems. Creating a Windows 95 boot disk Note: These steps are for users who have Windows 95 installed on the computer.

Select the Last Known Good Configuration item from the menu and press [Enter].